* Charles Nadeau <charles [ dot ] nadeau [ at ] gmail [ dot ] com> [090319 22:35]:
> > Do you boot with an initrd or do you have a custom kernel?
>
> I have a custom kernel
You clearly don't boot off this raid array, and I can see that you have
built MD and RAID modules into the kernel but left the ahci ones out.
I suggest you either edit your kernel-source/.config to have CONFIG_MD=m
(a module) or CONFIG_SATA_AHCI=y (a built-in). Doing both should be
safe also.
Another alternative could be to set CONFIG_MD_AUTODETECT=n, which would
cause the kernel to not even try to bring up the raid array.
Then run:
make oldconfig
grep -e CONFIG_MD -e CONFIG_SATA_AHCI .config
# verify that the CONFIG_MD and CONFIG_SATA_AHCI were not reverted
make
make install
That should make the kernel probe the hardware before brining up the
raid.
-Bart
> Ottawa Virtual Machines # lsmod
> Module Size Used by
> vmnet 32576 13
> vmmon 1840076 0
> snd_pcm_oss 41920 0
> snd_mixer_oss 16768 1 snd_pcm_oss
> snd_seq_oss 32640 0
> snd_seq_midi_event 8640 1 snd_seq_oss
> snd_seq 56992 4 snd_seq_oss,snd_seq_midi_event
> snd_seq_device 8148 2 snd_seq_oss,snd_seq
> snd_hda_intel 461740 7
> snd_pcm 84808 4 snd_pcm_oss,snd_hda_intel
> snd_timer 23376 4 snd_seq,snd_pcm
> nvidia 7804328 26
> snd 66760 18
> snd_pcm_oss,snd_mixer_oss,snd_seq_oss,snd_seq,snd_seq_device,snd_hda_intel,snd_pcm,snd_timer
> soundcore 8544 1 snd
> aic7xxx 146812 0
> snd_page_alloc 9616 2 snd_hda_intel,snd_pcm
> ahci 34184 8
> i2c_nforce2 7296 0
--
WebSig: http://www.jukie.net/~bart/sig/