It's not uncommon to 3d print a part for this type of bracket for older hard to order stuff. The question is do you have a more specific meassurement or part number to go on. Purely for fun, I dug up my spare drive brackets and found something similar, but there is no guarantee any of those will fit. I rember back in the day that there were differnet types for different bays or enclosures but some worked universally. I shall pm you link. I'd hate to have to see you file down, or worse force fit a part that doesn't match. BTW, that's good national pride about using what already exists in Canada first.. but for $7.89 it shows your dedication in current times... :-) - Allan ----- Original Message ----- From: Brenda J. Butler via linux <linux [ at ] linux-ottawa [ dot ] org> To: Linux-Ottawa <linux [ at ] linux-ottawa [ dot ] org> Sent: Fri, 28 Feb 2025 15:11:30 -0500 (EST) Subject: [linux] Looking for CoolerMaster HDD rails I need some extra CoolerMaster HDD rails - does anyone have any extras lying around? I inquired at RBComputing - they don't have any. They say they don't need them any more and (sob) threw them out. I don't buy from online sources, they do have them at Amazon, NewEgg etc. But ... I'd rather not get them from those places. Plan C is to somehow make something. But first, Plan B: ask around. bjb To unsubscribe send a blank message to linux+unsubscribe [ at ] linux-ottawa [ dot ] org To get help send a blank message to linux+help [ at ] linux-ottawa [ dot ] org To visit the archives: https://lists.linux-ottawa.org To unsubscribe send a blank message to linux+unsubscribe [ at ] linux-ottawa [ dot ] org To get help send a blank message to linux+help [ at ] linux-ottawa [ dot ] org To visit the archives: https://lists.linux-ottawa.org