I guess it should work but never been playing with asterisk,voip or so I'm asking for an over all opinion. Customer has 3 POTS to an old Talkswitch ct.ts001 pbx and from that it then goes over intranet to a pile of voip phones (talkswitch TS-350i). The system has started to act up a bit (it cut out incoming sound for all phones) and I'm looking at options. Assuming I can't figure out what's wrong with the current one I'm thinking it might be time to replace it and then the obvious choice (to me - not to fortinet) is asterisk on a rpi. 30 sec google and it should be possible. The option of dropping the pots and going 100% voip is not available - long term contract with Bell so another 30 sec search and I found that linksys PAP2 could be used to make the pots available to rpi/asterisk. Q: Is this a path that sounds good ? I hope that asterisk can talk to the talkswitch phones or could that be some issue ? Is PAP2 the way to go or is it some other one better ? Anything to watch out for ? I already have a rpi there but instead of adding asterisk to it I would add another rpi to not mix functions to much, or is that overkill ? -- ------------------------------------------------------------------- Techwiz, Peter Sjoberg GPG key (42DDDDDD) on keyserver & homepage Key fingerprint = EB81 3135 1636 576A DA83 826B 2455 0E88 42DD DDDD Homepage: http://www.techwiz.ca/~peters Pictures: http://www.flickr.com/photos/henahadu/ Enigma: http://meinEnigma.com