I did ssuch installs in the past, mainly using Ubuntu and derivatives. My main thing was to start with the installation USB key (with Ventoy or other way of installing a Linux), but ONLY this key first. I then waited until the LIVE distro was started. I THEN inserted the destination key in another USB port. Started the install process. In my case, the install process was started after booting the live distro. In the setup steps, I selected the second USB key as the destination. More importantly, and this is perhaps more specific to Ubuntu and derivatives, I made sure that the bootloader is installed on the same USB key as where the Linux distro was installed. JFM On Mon, Nov 16, 2026 at 11:25 AM Nash JC - NCF via linux < linux [ at ] linux-ottawa [ dot ] org> wrote: > I put this on the NCF Free Software discussion list, but perhaps some LO > folk may be interested. > > Over a number of years I've used live-distros (starting with Knoppix two > decades ago) and found them quite useful. More > recently, I've been interested in persistence so various apps and packages > can be added, and configuration > customizations made easier. This last weekend I tried out making a flash > drive that could be used to hold some important > data but also access that data using the live-distro on a "borrowed" PC. > This took a few tries, as the tools suggested > didn't work either as intended or as I understood their usage. However, I > think I now have a "recipe", but of course it > is for just one flavour of distro. I'm using Ventoy as the base platform. > If anyone else interested, it could be useful > to toss ideas back and forth to arrive at a write-up aimed at "competent > but not expert users". > > Cheers, John Nash > > > To unsubscribe send a blank message to linux+unsubscribe [ at ] linux-ottawa [ dot ] org > To get help send a blank message to linux+help [ at ] linux-ottawa [ dot ] org > To visit the archives: https://lists.linux-ottawa.org > >