On 13-08-26 08:38 AM, Eric Brackenbury wrote:
For those who may be interested :-) Eric B http://www.gizmag.com/opendesk-open-source-diy-furniture/28813/?utm_source=Gizmag+Subscribers&utm_campaign=4d74288da2-UA-2235360-4&utm_medium=email&utm_term=0_65b67362bd-4d74288da2-91236253
I will agree with the comment on the site, that the design shown does not pay any attention to efficient use of material. Of course part of the problem is the old try to make something out of one piece of plywood problem. cutting different parts out of different sheets would likly allow more room for economical design.
-- Charles MacDonald Stittsville Ontario cmacd [ at ] zeusprune [ dot ] ca Just Beyond the Fringe http://Charles.MacDonald.org/tubes No Microsoft Products were used in sending this e-mail.